Shop

We adopt the advanced microelectronic control system for the device. The process completes automatically from intake water to output ice and no need to operate with personnel, it is simple and convenient to reach the efficiency of plug-and-play. The user only needs to match the intake tube and drain tube; it can be used as soon as switched. 2. During operation, the ice cube machine should stop with full ice piece and run again after removing ice piece, the user does not need to disconnect the power switch. 3. The lowest operation temperature of the ice cube machine in the room is 10 C and the highest is 30 C. 4. The heavy or hot objects should not be put on the top of the ice cube so to avoid deformation. 5. During handling, the dip angle should not larger than 45°. It should be strictly prohibited side standing or inversion. 6. The ice cube machine must be placed horizontally in order to avoid affecting the regeneration efficiency and producing vibration and noise. 7. The ice cube machine should be placed with aeration and drying, the distances from the wall in the side and back should both be larger than 20cm 8. The water for producing ice should meet to the national standards about drinking water health. 9. It should be strictly prohibited to switch the machine on the condition of the water pump damaged. 10. When the machine is not be used, please clean the inside of the machine with soft cloth and should keep airiness to avoid corrosion. 11. The individual socket must be used for the power source, the current capacity of the socket and wire should not be smaller than 15A, and the socket must be reliably grounded. 12. The power source should be single phase AC with 50Hz, the voltage should be 200-230V, if the voltage is not stable, the voltage stabilizer over 1000W should be used. 13. During operation, it should avoid switching and disconnecting the power frequently, the power should be switched within 10 minutes after disconnecting but not prompt switching. 14. If the condenser has more dust and oil, it would affect the aeration and dissipation, so it should be cleaned timely; if not, it would affect the producing ice efficiency and the service life of the machine. When cleaning, the power source should be disconnected and packed with the film to avoid leakage. It had better be cleaned every month. 15. If the user needs to adjust the thickness of the ice piece, please contact with our maintaining department.